Introduction

Carries out skilled fault-finding, repair, installation, maintenance and overhaul work on a range of pneumatic, electrical and electronic instrumentation and Control/Plant Safety System, in workshop and on-site.
Also carries out hardware checks and troubleshooting of various cards/modules of Distributed Control Systems (DCS), Emergency Shutdown Systems (ESD), Fire and Gas Detection Systems (FGD) and carries out detail work as directed by Senior Technician.
Assists in routine aspects of work and complete records and forms, detailing work carried out, in either of the NGL Plants, North Field Facilities, NGL/Storage & Loading Areas within NGL Complex.

About this role

Carries out faultfinding, repair, installation, maintenance, modification and overhaul work on a range of Process Control/Safety Instrumentation System in any Oil & Gas processing plant and Storage & Loading facilities
Carries out skilled fault-finding, repair, maintenance, installation, testing, calibration, loop checking, overhauls on a range of pneumatic, hydraulic, electrical, electronic control and safety instrumentation systems, process analyzers, DCS, ESD, F&G, SCADA, PLC, Rotating Equipment
controls, vibration monitoring system, Loading arms controls, Tank gauging and inventory management system, custody meters, Flare ignition controls & flame monitoring and various flare flow meters in oil and gas industry.
Shall be responsible for obtaining or issuing appropriate Hot or Cold Work Permits and other Certificates as necessary.
Maintenance of Plant fire &gas detection and protection systems such as flammable & toxic gas sensors, Tank Rim-seal fire detection & protection systems, plant deluge & foam systems, Firewater pump controls, fire alarm systems.
To complete records of work performed and reports details of installation, workshop overhaul and repair, preventative maintenance, and fault-finding/repair work carried out to Senior Technician.
Includes completing instrument calibration test sheets, service records and log registers.
Interpret/mark-up technical drawings.
To serve on standby duty to attend to urgent instrument problems outside working hours.
Test equipment calibration and maintenance, exercising good housekeeping in all activities and observing all fire and safety precautions.
Fully conversant with Permit to work system & shall have Level 1/2 authorization.

Is this you?

Completion of Secondary (12 years) education, followed by Higher National Certificate or equivalent. In addition, relevant short courses in safety. Fair knowledge of computer and networking.
A minimum of 5 years’ Relevant Maintenance Experience in Oil & Gas or Petrochemical industry.
Experience in the installation, maintenance and overhaul of pneumatic, electrical and electronic process control and safety instrumentation within a hydrocarbon/oil refinery or gas processing plant.